Jeep Cherokee 2000 Service Manual - page 1357
NOTE: Force the cowl grille rearward while tighten-
ing the screws.
(4) Install the windshield wiper arms on the piv-
ots.
BODY DECALS
Small nicks, scratches and other surface marks in
a decal can be touched-up with paint.
To eliminate blisters and air bubbles in a decal,
pierce them with a needle or pin.
A heat gun can also be used to remove small wrin-
kles in a decal.
Decal replacement requires that the metal repair
and paint refinish be completed first.
The work area temperature should be between
21°C (70°F) and 32°C (90°F). A decal should not be
replaced if the work area temperature is less
than 21°C (70°F).
The following equipment and material are neces-
sary for removal and installation:
• Liquid dish detergent (for the wetting solution).
• Mixture of wetting solution.
• Commercial wax and silicone removal solution.
• Isopropyl (rubbing) alcohol.
• Small squeegee (plastic or hard rubber).
• Water bucket and sponge.
• Clean wiping rags or paper towels.
• Heat gun (or infra-red heat bulb).
• Wax pencil.
• Sharp knife, single edge razor blade or X-acto
knife.
• Pair of scissors.
• Needle or pin.
WARNING: USE DECAL REMOVAL SOLUTION IN A
WELL-VENTILATED AREA ONLY.
A decal removal solution can be used for removal
at areas where a heat gun is ineffective. Follow the
manufacturers instructions whenever this type of
product is used.
REMOVAL
(1) Clean the repaired surface as necessary.
(2) Start at one end of the decal and apply heat
with a heat gun. Slowly peel the decal from the panel
by pulling it back. Do not pull the decal outward
from panel.
INSTALLATION
(1) The area that will be covered by the decal must
be cleaned with cleaning solution.
(2) Freshly painted surfaces must be thoroughly
dry.
(3) Clean the painted surface with a commercial
wax and silicone removal solution. Wipe the surface
with a clean cloth and allow it to dry.
(4) Prepare a wetting solution by mixing two or
three teaspoons of dish detergent with 1 gallon of
water. Do not use soap.
NOTE: Too much detergent will reduce the effec-
tiveness of the mixture.
(5) Use a clean sponge and apply the wetting solu-
tion to the adhesive side of the decal and to the
painted panel surface. The wetting solution will per-
mit ease of decal movement when positioning it.
Fig. 11 Cowl Grille, Screen & Washer Nozzles
1 – PLASTIC PUSH-RIVET
2 – SCREEN
3 – SCREEN
4 – RIVET
5 – NOZZLE
6 – GRILLE
7 – PLASTIC PUSH-RIVET
8 – GRILLE
9 – NOZZLE
Fig. 12 Cowl Grille Screw Tightening Sequence
XJ
BODY
23 - 29
REMOVAL AND INSTALLATION (Continued)