Jeep Cherokee 2000 Service Manual - page 971
Other manuals for Cherokee 2000:
Service Manual
of
1528
(13) Invert output shaft and set the shaft in
Remover 6310-1 so that fifth gear is seated on the
tool (Fig. 67).
(14) Install first gear bearing on output shaft (Fig.
67). Be sure bearing is seated on shaft shoulder and
is properly joined.
(15) Install first gear on shaft and over bearing
(Fig. 68). Make sure bearing synchro cone is facing
up as shown.
Fig. 65 Installing Fifth Gear Bearing
1 – SHAFT SHOULDER
2 – FIFTH GEAR BEARING
Fig. 66 Fifth Gear Installation
1 – FIFTH GEAR
2 – BEARING
Fig. 67 First Gear Bearing Installation
1 – FIRST GEAR BEARING
2 – SHAFT SHOULDER
3 – SPECIAL TOOL
6310–1
4 – PRESS BLOCKS
Fig. 68 First Gear Installation
1 – FIRST GEAR
2 – SPECIAL TOOL
6310–1
3 – BEARING
XJ
NV3550 MANUAL TRANSMISSION
21 - 63
DISASSEMBLY AND ASSEMBLY (Continued)