Jeep Cherokee 2000 Service Manual - page 1238
DISASSEMBLY
(1) Remove output shaft from gear assembly (Fig.
287).
(2) Remove and discard shaft seal ring (Fig. 288).
(3) Remove brake pack from planetary gear (Fig.
289).
(4) Remove planetary gear from ring gear (Fig.
290).
(5) Check No. 2 one–way clutch (Fig. 291). Hold
planetary gear and turn clutch inner race in both
directions. Race should turn freely counterclockwise,
but lock when turned clockwise. Replace one–way
clutch if necessary.
Fig. 287 Removing/Installing Output Shaft
1 – GEAR ASSEMBLY
2 – OUTPUT SHAFT
Fig. 288 Removing/Installing Shaft Seal Ring
1 – SEAL RING
2 – OUTPUT SHAFT
Fig. 289 Removing/Installing First–Reverse Brake
Pack
1 – FIRST-REVERSE BRAKE PACK
2 – REAR PLANETARY GEAR
Fig. 290 Removing/Installing Rear Planetary
1 – REAR PLANETARY GEAR
2 – RING GEAR
21 - 330
AW–4 AUTOMATIC TRANSMISSION
XJ
DISASSEMBLY AND ASSEMBLY (Continued)