Jeep Cherokee 2000 Service Manual - page 157
ASSEMBLY
(1) Install the differential side gears and thrust
washers.
(2) Install the differential pinion gears and thrust
washers.
(3) Install the pinion mate shaft.
(4) Align the hole in the pinion mate shaft with
the hole in the differential case and install the pinion
mate shaft lock screw.
(5) Lubricate
all
differential
components
with
hypoid gear lubricant.
TRAC-LOK
Y DIFFERENTIAL
The Trac–lok
y differential components are illus-
trated in (Fig. 38). Refer to this illustration during
repair service.
DISASSEMBLY
(1) Clamp Side Gear Holding Tool 8138 in a vise.
(2) Position the differential case on Side Gear
Holding Tool 8138 (Fig. 39).
(3) Remove ring gear, if necessary. Ring gear
removal is necessary only if the ring gear is to be
replaced. The Trac-lok
y differential can be serviced
with the ring gear installed.
Fig. 37 Pinion Mate Gear Removal
1 – THRUST WASHER
2 – SIDE GEAR
3 – PINION MATE GEAR
Fig. 38 Trac–lok
Y
Differential Components
1 – THRUST WASHER
2 – PINION
3 – SHAFT LOCK SCREW
4 – PINION MATE SHAFT
5 – SIDE GEAR
6 – RETAINER
7 – DISC
8 – CLUTCH PACK
9 – DIFFERENTIAL CASE
10 – RETAINER
XJ
8 1/4 REAR AXLE
3 - 121
DISASSEMBLY AND ASSEMBLY (Continued)