Jeep Cherokee 2000 Service Manual - page 1361
FRONT DOOR TRIM PANEL
REMOVAL
(1) Roll window down.
(2) Remove window crank, if equipped (Fig. 21).
(3) Remove the screws attaching the trim panel to
the door inner panel (Fig. 22) and (Fig. 23).
(4) Separate the trim panel fasteners from door
inner panel with a pry tool (use special tool C-4829)
(Fig. 24).
(5) Lift the trim panel up and outward to separate
from the inner belt seal.
(6) Move the door trim panel outward and discon-
nect the handle-to-latch rods.
(7) Disconnect the power door locks/windows/mir-
rors wire harness connectors, if equipped.
(8) Remove the trim panel from door.
INSTALLATION
(1) Replace any broken or damaged push-in fasten-
ers.
(2) Connect the power door locks/windows/mirrors
wire harness connectors, if equipped.
(3) Move the door trim panel outward and connect
the handle-to-latch rods.
(4) Position the trim panel on the inner belt seal
and push down to seat.
(5) Align the locating pins and push- (Fig. 25) in
fasteners. Press inward to secure.
(6) Install the screws attaching the trim panel to
the door inner panel.
(7) Install the window crank, if equipped.
Fig. 19 Right Front Fender
1 – SCREW
2 – HOOD BUMPER
3 – U-NUT
4 – INNER FENDER PANEL
5 – FENDER BRACE
6 – FRAME SILL-TO-BAFFLE BRACE
7 – U-NUT
8 – OUTER FENDER PANEL
9 – U-NUT
Fig. 20 Inner Support Bracket
1 – U-NUT
2 – FRONT FENDER
3 – SUPPORT BRACKET
XJ
BODY
23 - 33
REMOVAL AND INSTALLATION (Continued)