Jeep Cherokee 2000 Service Manual - page 1383
(4) Position the quarter panel trim on the quarter
panel and wheelhouse cover.
(5) Install the screws attaching quarter panel trim
on the quarter panel and wheelhouse cover
(6) Install liftgate scuff plate.
(7) Install quarter panel trim extension.
(8) Install the inner scuff plate.
LIFTGATE PILLAR TRIM
REMOVAL
(1) Remove the liftgate opening upper trim.
(2) Remove the liftgate pillar trim screws (Fig. 70).
(3) Remove the screws attaching the lower quarter
panel trim to the liftgate pillar.
(4) Pull the trim panel outward to detach the
spring steel clips attaching the trim panel to the pil-
lar (2-dr vehicles).
(5) Remove liftgate pillar trim.
INSTALLATION
(1) Position the liftgate pillar trim on the liftgate
pillar.
(2) Press the trim panel into place to engage the
spring steel clips attaching the trim panel to the pil-
lar (2-dr vehicles).
(3) Install the screws attaching the lower quarter
panel trim to the liftgate pillar.
(4) Install the liftgate pillar trim screws.
(5) Install the liftgate opening upper trim.
LIFTGATE OPENING UPPER TRIM
REMOVAL
(1) Remove the screws attaching the liftgate open-
ing upper trim to the roof panel (Fig. 71).
(2) Pull downward to disengage steel clips attach-
ing the liftgate opening upper trim to the roof panel.
(3) Separate trim from vehicle.
INSTALLATION
Steel clips are used for manufacturing purposes
and are not required for service.
(1) Position trim on roof panel.
(2) Install the screws attaching the liftgate open-
ing upper trim to the roof panel.
LIFTGATE SCUFF PLATE
REMOVAL
(1) Remove the screws attaching the liftgate scuff
plate to the floor pan (Fig. 72).
(2) Separate the scuff plate from the vehicle.
INSTALLATION
(1) Position the scuff plate on the vehicle.
(2) Center striker in opening.
(3) Install the screws attaching the liftgate scuff
plate to the floor pan.
FRONT SHOULDER BELT/BUCKLE
CAUTION: Inspect the front shoulder belts and
buckles. Replace any belt that is either cut, frayed,
torn or damaged in any way. Replace the shoulder
belt if the retractor is damaged or inoperative.
Fig. 70 Liftgate Pillar Trim
1 – UPPER LIFTGATE OPENING TRIM
2 – UPPER LIFTGATE PILLAR TRIM
3 – LOWER QUARTER TRIM
Fig. 71 Liftgate Opening Upper Trim
1 – UPPER LIFTGATE OPENING TRIM
XJ
BODY
23 - 55
REMOVAL AND INSTALLATION (Continued)