Jeep Cherokee 2000 Service Manual - page 1071
(46) Place adjusting screw bracket and line pres-
sure adjusting screw in position on valve body and
compress springs (Fig. 94).
(47) Install screws to attach adjuster bracket to
valve body.
TRANSMISSION
DISASSEMBLY
(1) Remove transmission from vehicle.
(2) Install a suitable tail shaft housing plug to
avoid contaminating internal components with clean-
ing solvents.
(3) Clean exterior of transmission with suitable
solvent or pressure washer.
(4) Remove torque converter from transmission.
(5) Remove throttle and shift levers from valve
body manual shaft and throttle lever shaft.
(6) Mount transmission in repair stand C-3750-B
or similar type stand (Fig. 123).
(7) Remove extension housing.
(8) Remove fluid pan.
(9) Remove park/neutral position switch and seal
(Fig. 124).
(10) Remove valve body.
(11) Remove accumulator spring and piston (Fig.
125).
(12) Loosen front band adjusting screw lock nut
(Fig. 126) 4-5 turns. Then tighten band adjusting
Fig. 113 Valve Body Transfer Plate Screws
1 – TRANSFER PLATE
2 – VALVE BODY
3 – SEPARATOR PLATE
Fig. 116 Converter Clutch Solenoid
1 – VALVE BODY
2 – TORQUE CONVERTER CLUTCH SOLENOID
Fig. 117 Park Rod
1 – MANUAL LEVER
2 – E-CLIP
3 – PARK ROD
Fig. 118 Securing Detent Ball And Spring With
Retainer Tool
1 – SPECIAL TOOL 6583
2 – DETENT BALL AND SPRING HOUSING
XJ
AUTOMATIC TRANSMISSION—30RH
21 - 163
DISASSEMBLY AND ASSEMBLY (Continued)