Jeep Cherokee 2000 Service Manual - page 946
COUNTERSHAFT
Inspect the countershaft gear teeth. Replace the
countershaft if any teeth are worn or damaged.
Inspect the bearing surfaces and replace shaft if any
surface shows damage or wear.
Check condition of the countershaft front bearing.
Replace the bearing if worn, noisy, or damaged.
GEAR AND SYNCHRONIZER
Install the needle bearing and inner race in the
first gear. Then check oil clearance between the gear
and inner race (Fig. 121). Clearance should be 0.009
– 0.032 mm (0.0004 – 0.0013 in.).
Install the needle bearings and the second, third
and counter fifth gears on the output shaft. Then
check oil clearance between the gears and shaft with
a dial indicator (Fig. 122). Oil clearance for all three
gears is 0.009 – 0.0013 mm (0.0004 – 0.0013 in.).
Check synchronizer ring wear (Fig. 123). Insert
each ring in matching gear. Measure clearance
between each ring and gear with feeler gauge.
Replace ring if clearance exceeds 2.0 mm (0.078 in.).
Check shift fork–to–synchronizer hub clearance
with a feeler gauge (Fig. 124). Replace the fork if
clearance exceeds 1.0 mm (0.039 in.).
(1) Inspect all mainshaft gear teeth. Replace any
gear which shows any worn or damaged teeth.
Fig. 119 Check Shaft And Bearing Race Flange
Thickness
1 – OUTPUT SHAFT FLANGE
2 – INNER RACE FLANGE
Fig. 120 Check Output Shaft Runout
1 – OUTPUT SHAFT JOURNAL
Fig. 121 Check Gear–To–Race Clearance
1 – GEAR
2 – INNER RACE
21 - 38
AX5 MANUAL TRANSMISSION
XJ
CLEANING AND INSPECTION (Continued)