Jeep Cherokee 2000 Service Manual - page 1299
(6) Remove input gear bearing with Tool Handle
C-4171 and Remover C-4210 (Fig. 52).
(7) Install snap-ring on new input gear bearing.
(8) Install new input gear bearing with Tool Han-
dle C-4171 and Remover C-4210. Install bearing far
enough to seat snap-ring against case (Fig. 53).
(9) Remove the input gear pilot bearing by insert-
ing a suitably sized drift into the splined end of the
input gear and driving the bearing out with the drift
and a hammer (Fig. 54).
(10) Install new pilot bearing with Installer 8128
and Handle C-4171 (Fig. 55).
(11) Install new seal in front bearing retainer with
Installer 7884 (Fig. 56).
(12) Remove output shaft rear bearing with the
screw and jaws from Remover L-4454 and Cup 8148
(Fig. 57).
Fig. 51 Install Front Output Shaft Seal
1 – INSTALLER 6952–A
2 – TRANSFER CASE
Fig. 52 Input Gear Bearing Removal
1 – SPECIAL TOOL C-4171
2 – SPECIAL TOOL C-4210
Fig. 53 Seating Input Gear Bearing
1 – SNAP RING
2 – INPUT SHAFT BEARING
Fig. 54 Remove Input Gear Pilot Bearing
1 – DRIFT
2 – INPUT GEAR
XJ
NV242 TRANSFER CASE
21 - 391
DISASSEMBLY AND ASSEMBLY (Continued)