Jeep Cherokee 2000 Service Manual - page 1360
FRONT WHEELHOUSE LINER
REMOVAL
(1) Hoist vehicle.
(2) Remove tire.
(3) Remove the push-in fasteners attaching the
wheelhouse liner to the inner fender.
(4) Separate the wheelhouse liner from the fender
(Fig. 18).
INSTALLATION
(1) Position the wheelhouse liner in the fender.
(2) Install new push-in fasteners attaching the
wheelhouse liner to the inner fender.
(3) Install tire.
(4) Lower vehicle.
RIGHT FRONT FENDER
REMOVAL
(1) Raise and support the hood.
(2) Remove the grille opening panel (GOP).
(3) If equipped, remove the radio antenna mast,
and components from the fender.
(4) Remove the coolant recovery bottle.
(5) Raise and support the vehicle.
(6) Remove the right front wheel.
(7) Remove the front bumper end cap.
(8) Remove the wheelhouse liner.
(9) Remove the fender flare and retainers.
(10) Disconnect all wire harness connectors.
(11) Remove the air deflector.
(12) Remove the fender lower screws (Fig. 19).
(13) Remove the fender top, front and the rear
screws.
(14) Remove the screws attaching the fender to the
inner support bracket (Fig. 20).
(15) Separate the fender from the inner fender
panel.
INSTALLATION
(1) Position the fender on the inner fender panel.
(2) Install all fender screws finger-tight.
(3) Align the fender with the body panels and
tighten the screws attaching the fender to the body
panels.
(4) Install the air deflector.
(5) Install the fender flare and retainers.
(6) Install the wheelhouse liner.
(7) Install the front bumper end cap.
(8) Install the wheel, remove the support and
lower the vehicle.
(9) Install the grille opening panel (GOP).
(10) Install the radio antenna.
LEFT FRONT FENDER
REMOVAL
(1) Raise and support the hood.
(2) Remove the grille opening panel (GOP).
(3) Raise and support the vehicle.
(4) Remove the left front wheel.
(5) Remove the front bumper end cap.
(6) Remove the fender flare and retainers.
(7) Remove the wheelhouse liner.
(8) Remove the air deflector.
(9) Remove the fender lower screws.
(10) Remove the fender top, front and the rear
screws.
(11) Remove the screws attaching the fender to the
inner support bracket.
(12) Separate the fender from the inner fender
panel.
INSTALLATION
(1) Position the fender on the inner fender panel.
(2) Install all fender screws finger-tight.
(3) Align the fender with the body panels and
tighten the screws attaching the fender to the body
panels.
(4) Install the air deflector.
(5) Install the wheelhouse liner.
(6) Install the fender flare and retainers.
(7) Install the front bumper.
(8) Install the wheel, remove the support and
lower the vehicle.
(9) Install the grille opening panel (GOP).
Fig. 18 Front Wheelhouse Liner
1 – FENDER
2 – WHEELHOUSE LINER
3 – INNER FENDER PANEL
4 – BRACE
5 – PUSH-IN FASTENER
6 – RETAINER
23 - 32
BODY
XJ
REMOVAL AND INSTALLATION (Continued)