Jeep Cherokee 2000 Service Manual - page 993
Shift Socket
Inspect the shift socket for wear or damage.
replace the socket if the roll pin, or shift shaft bores
are damaged. Minor nicks in the shift lever ball seat
in the socket can be smoothed down with 400 grit
emery or wet/dry paper. Replace the socket if the ball
seat is worn, or cracked. Do not reuse the original
shift socket roll pin. Install a new pin during reas-
sembly. The socket roll pin is approximately is
approximately 33 mm (1-1/4 in.) long.
Output Shaft And Geartrain
Inspect all of the gears for worn, cracked, chipped,
or broken teeth. Also check condition of the bearing
bore in each gear. The bores should be smooth and
free of surface damage. Discoloration of the gear
bores is a normal occurrence and is not a reason for
replacement. Replace gears only when tooth damage
has occurred, or if the bores are brinnelled or
severely scored.
Inspect the shaft splines and bearings surfaces.
Minor nicks on the bearing surfaces can be smoothed
with 320/420 grit emery and final polished with cro-
cus cloth. Replace the shaft if the splines are dam-
aged or bearing surfaces are deeply scored, worn, or
brinnelled.
SPECIFICATIONS
TORQUE
SPECIAL TOOLS
NV3550 MANUAL TRANSMISSION
Fig. 135 Correct Countershaft Bearing Installation
1 – COUNTERSHAFT
2 – BEARING CAGE
Description
Torque
Clutch Housing Bolts . . . 54–61 N·m (40–45 ft. lbs.)
Crossmember-To-Frame Bolts . . . . . . . . 61–75 N·m
(44–55 ft. lbs.)
Crossmember-To-Insulator Nuts . . . . . . 54–61 N·m
(40–45 ft. lbs.)
Drain/Fill Plug . . . . . . . . . 9–27 N·m (14–20 ft. lbs.)
Front-To-Rear Housing Bolts . . . . . . . . . 30–35 N·m
(22–26 ft. lbs.)
Front Bearing Retainer Bolts . . . . . . . . . 7–10 N·m
(5–7 ft. lbs.)
Idler Shaft Bolts . . . . . . 19–25 N·m (14–18 ft. lbs.)
Rear Bearing Retainer Bolts . . . . . . . . . 30–35 N·m
(22–26 ft. lbs.)
Shift Tower Bolts . . . . . . . . . 7–10 N·m (5–7 ft. lbs.)
Slave Cylinder Attaching Nuts . . . . . . . . . . 23 N·m
(200 in. lbs.)
Transfer Case Attaching Nuts . . 47 N·m (35 ft. lbs.)
U-Joint Clamp Bolts . . . . . . . . 19 N·m (170 in. lbs.)
Remover, Seal—C-3985-B
Installer, Seal—C-3972-A
XJ
NV3550 MANUAL TRANSMISSION
21 - 85
CLEANING AND INSPECTION (Continued)