Riso RZ 970 Series User Manual - page 19
Before Starting to Use
Originals
18
Maximum Printing Areas and Margins
The maximum printing areas are as follows.
Important!:
• No matter which size of originals is printed, the margins indicated on the figure are required for the originals.
Reduce the original if necessary to fit it inside of the margins. Place an original so that its end having a 5 mm margin
at least comes to the left of the Platen Glass.
Tip:
About Printing Areas
• Printing area for the master is determined by the actual paper size detected on the Standard Feed Tray, Feed
Tray 1 or Feed Tray 2, regardless of whether the original is being scanned, or sent from a computer.
• As shown in the illustration above, the printing area on the master will be smaller than the paper size (allowing
7 mm total margins for top and bottom, 6 mm for left and right). Peripheral areas in the original document exceed-
ing the printing area for the master will not be printed.
• The maximum printing area can be applied to the scanned image, regardless of the print paper size.
)
p.139
Materials Not to Be Printed
Do not use the machine in any manner which violates the law or infringes on established copyrights, even when mak-
ing copies for personal use. Consult your local authorities for further details. In general, use discretion and common
sense.
Maximum Printing Area
Usable Maximum Print Paper Size
291 mm
× 413 mm
Standard Feed Tray: 320 mm
× 432 mm
Feed Tray 1/2: 297 mm
× 432 mm