Riso RZ 970 Series User Manual - Replenishing Paper
Replacing Consumables
Replenishing Paper
203
Replenishing Paper
Setting Paper in Feed Trays (for RZ977 only)
Both Feed Tray 1 and Feed Tray 2 should be filled as follows:
Requirements for paper that can be set in Feed Trays
Size: B5-A3 (297 mm
× 432 mm) (including custom-size)
Weight (thickness): 52-105 g/m
2
Important!:
Set paper in the Standard Feed Tray in the following cases (not in the feed trays).
• Printing on extended paper and special kinds of paper (e.g. thicker ones)
• Printing on the back side of the output (for duplex printing)
• Multi-colour printing (overprinting)
1
Pull out the Feed Trays.
Pull out the tray where paper is set.
2
Release the Paper Guide Lock to
widen the Paper Guide.
1)
Move the Paper Guide Lock Levers on either
side to the “free” position.
2)
Widen the Paper Guides as much as possi-
ble.
3
Set the Paper Stopper.
Adjust the Stopper for size and orientation of
paper in the tray.
1)
Lift the Stopper straight up while pressing the
hook button, and remove the Stopper.
2)
Keep pressing the hook button, and push the
Stopper straight down, aligning the
mark
on the Stopper with the paper size scale.
Remove the Stopper when using A3-sized
paper. Insert the removed Stopper in the
holder inside the tray.
Free
Lock
Hook
Button