Riso RZ 970 Series User Manual - page 224
Troubleshooting
When a Message Displays
223
T00-000:Service Call Error (in alphabetical order)
A00-000:Master Jam Errors (in alphabetical order)
Message
Possible Cause
Action
!!Battery Replacement!!
Call Service
The battery is low or depleted.
Contact your dealer (or authorised service
representative) and have the battery
replaced.
Press the
key or the
key to clear
the error message display.
!!System Error!!
Press Reset Key
If Recovery has Failed, Call Service
A system error has occurred.
Press the
key.
If the problem persists, contact your dealer
(or authorised service representative).
!!System Error!!
Turn Main Power SW OFF Then ON
If Recovery has Failed, Call Service
Shut off power, then restart.
If the problem persists, contact your dealer
(or authorised service representative).
Message
Possible Cause
Action
Master Disposal Error
Pull Out Print Drum and
Discard Master
The master was not properly
discarded.
1)
Pull out the Print Drum and remove
the master from the drum.
2)
Return the Print Drum in place.
3)
Press the
key.
Master Jammed in Disposal Unit
Pull Out Master Disposal Box and
Remove Jammed Master
The master is jammed in the
Master Disposal Unit.
Pull out the Master Disposal Box and
remove the jammed master.
If the error persists, contact your dealer (or
authorised service representative).
Master Loading Error
Pull Out Print Drum and
Discard Master
The master did not properly
attach to the Print Drum.
1)
Pull out the Print Drum and remove
the master from the drum.
2)
Return the Print Drum in place.
3)
Press the
key.
Master Mis-Feed
Pull Out Master Making Unit and
Rewind Master Roll, then
Reset Master in Place
The master is improperly
installed.
Pull out the Master Making Unit, rewind
the master and reinstall.
Master Not Set in Place
Insert Lead Edge of Master into
Master
Entrance and Close Master Making
Unit
The master is improperly
installed or is missing.
Pull out the Master Making Unit and
reinstall the master.
Important!:
• If the leading edge of the master is
wrinkled or torn, cut the edge straight
and reinstall.