Riso RZ 970 Series User Manual - page 40
Basic Operations
Preparing to Print
39
Setting up the Paper Receiving Tray
(for RZ970)
For RZ970 models equipped with the optional Auto-control Stacking Tray, refer to “Setting up the Auto-control Stack-
ing Tray (for RZ977)” ()p.37).
1
Open the Paper Receiving Tray.
Pull the Paper Receiving Tray down until it comes
to a rest.
2
Position the Receiving Tray Paper
Guides.
1)
Raise the Receiving Tray Paper Guides.
2)
Hold their lower part and slide them to fit the
paper width.
Important!:
• For thick paper such as drawing paper, position
the Receiving Tray Paper Guides a little wider
than the actual paper width.
3
Set the Paper Stopper.
1)
Raise the Paper Stopper.
2)
Slide to fit the length of the paper.
4
Adjust the Paper Arrangers.
Alignment of paper is affected by sizes and
strength of paper. Adjust the Paper Arrangers so
that printed paper is aligned.
Press the Paper Arranger to push the plates out,
pull up to pull them in.
For plain paper
Press to open all of the four Paper Arrangers.
For plain paper with images
lopsided on page
Press to open the two Paper Arrangers on the
more heavily printed side.
Push out plates
Pull In