Riso RZ 970 Series User Manual - page 237
Troubleshooting
When a Message Displays
236
Check the Settings
The Sellected Reproduction
Ratio will not fit the
Max. Printing Area
(Symptom)
Reproduction size is too large for the
detected original size and exceeds the
maximum printing area.
(Action)
Modify the reproduction size.
• When changing the “Size” setting;
Touch [Size Setting].
• When resuming the print job;
Touch [Continue].
(Alternatively, press the
key to
print.)
• When stopping the print job;
Touch [Cancel].
(Alternatively, press the
key or
the
key to clear.)
Close Stage Cover
If original moves
you may not get
desired result
(Symptom)
The Platen Cover was opened during
the editing process of the RISO Editor
function.
(Action)
Close the Platen Cover gently.
Touch [Close].
(You can also solve the problem by
closing the Platen Cover.)
Enter Print Quantity Over
[nn],
Programmed Minimum Value
(Symptom)
You are trying to print fewer copies than
previously specified on “Minimum Print
Quantity”.
(Action)
Enter a larger number to print, or change
“Minimum Print Quantity” on the Admin.
screen.
Touch [Close], and specify the number
of copies higher than the number
displayed on the message.
!! Images may not fit
in Frame of Paper with
This Reproduction Size !!
Check Current Selection
(Symptom)
Reproduction size for the detected
original size is larger than paper size.
(Action)
Modify the reproduction size.
• When resuming the print job;
Touch [Continue].
(Alternatively, press the
key to
print.)
• When stopping the print job;
Touch [Cancel].
(Alternatively, press the
key or
the
key to clear.)
Invalid Print Drum
has been Selected
Change Drum, or
Reselect Drum Size
(Symptom)
You have selected a different Print Drum
than the one currently in place, as
confirmed in the Confirm Drum Type
screen when it was installed.
(Action)
Select the type of Print Drum currently installed.
Alternatively, you can change the Print
Drum.
)
p.213
• When changing a setting;
In the Confirm Drum Type screen,
select the type of Print Drum currently
installed and touch [OK].
• When installing a different Print Drum;
Pull out the Print Drum and replace
with the correct one.
When the Print Drum is re-installed, the
Warning Message will clear.
Message
Symptom/Action
How to Clear a Pop-Up Message