Riso RZ 970 Series User Manual - page 225
Troubleshooting
When a Message Displays
224
B00-000:Optional Device Error (in alphabetical order)
Master Remains on Print Drum
Pull Out Print Drum and
Remove Master
An unnecessary master
remains on the Print Drum.
1)
Pull out the Print Drum and remove
the master from the drum.
2)
Return the Print Drum in place.
Safety SW on Standard Feed Tray
is Activated
Reset paper on Standard Feed Tray
The safety switch for the
Standard Feed Tray has been
activated.
Check underneath the Standard Feed
Tray and on top of the printing paper for
any obstructions. Remove if any exist.
System Error in Master Making Unit
Take Out Master and then
Close Master Making Unit Cover
The cutter mechanism for the
master malfunctioned.
Pull out the Master Making Unit and
remove the master.
Closing the Master Making Unit Cover will
reset the error. Setup the master again.
Message
Possible Cause
Action
Close Feed Joint Passage Cover
Feed Joint Passage Cover is
open or incorrectly set.
Open the front cover, firmly close the lever
of the Feed Joint Passage Cover, and
then close the front cover.
Close Multi-Tray Transfer Unit
The Multi-Tray Transfer Unit of
the Feed Tray is open or
incorrectly set.
Check the Multi-Tray Transfer Unit and
close it firmly.
Insert Card in Key/Card Counter
No card in the Key Card
Counter (option).
Insert Card in the Key Card Counter.
!! Job Separator is OFF !!
Turn On Power Switch of it
The Job Separator (option) is
turned OFF.
Turn on the Job Separator.
Linked Printer in Error
A Service Call Error has
occurred on the Linked Printer.
Check the Linked Printer and resolve the
error.
No IP Address Assigned to This
Printer
Contact Your Network Administrator
IP address for the machine is
not properly set.
Contact your system administrator and set
the machine IP address correctly.
!! No Linked Printer Detected !!
Check Cable Connection and Power
Supply for Linked Printer
Linked Printer may not be
turned ON; cable may not be
properly connected; connection
may be interrupted.
Check that the Linked Printer has been
switched on.
Check to make sure all cables are
properly connected. If properly connected,
check for damaged cable.
Message
Possible Cause
Action