Riso RZ 970 Series User Manual - page 216
Replacing Consumables
Replacing the Print Drum (Colour Change)
215
Installing the Print Drum
1
Place the Print Drum on the Rail.
Align the
mark on the Print Drum with the
mark on the guide, and place the Print Drum hori-
zontally onto the guide.
Note:
• If the Print Drum was manually rotated, be sure
to turn it back so that
and
marks align,
after it is placed on the guide.
2
Return the Print Drum to its original
position.
Push the Print Drum in as far as it will go, and then
close the Front Cover.
Important!:
• Do not grasp the Print Drum Handle when
pushing in the Print Drum.
Tip:
Changing the Drum Type
When you install a different type of Print Drum, the
Confirm Drum Type screen appears.
1)
Select the type corresponding to the installed
Print Drum.
2)
Touch [OK].
The Print Drum type is confirmed and printing
is enabled.
Important!:
• You will not be able to print until the Print
Drum type is confirmed.
• If you install a non-approved Colour Drum,
the message “Wrong-Type Print Drum
Installed Replace with Correct Type” is dis-
played. Install a Colour Drum specifically
approved for use with this machine.
Ready to Make Master
Selections
Basic
Functions
Admin.
P.1/3
!!The Print Drum Type
has been Changed!!
Select the Current
Print Drum Type
F17
OK
A3 Drum
A4-R Drum