Riso RZ 970 Series User Manual - page 196
When using a Linked Printer (sold separately)
Duplex Printing [Duplex]
195
Important!:
• This step is not necessary unless using the
ADF unit. Continue on to step 4.
4
Touch [OK].
Note:
• To cancel Duplex Printing, touch [OFF] then
[OK].
5
Place the original.
Note:
• For information about placing the original, see
step 4, “Printing from a Paper Document or
Book”.()p.41)
• To scan a single sheet of an original, place it on
the Platen Glass.
• When Duplex Printing from odd number of orig-
inals scanned in the ADF unit, the reverse side
of the last page will be blank.
6
Select Print functions as needed.
The following functions are available:
• Image Processing mode ()p.52)
• Scanning Contrast ()p.54)
• Size ()p.55)
• Feed Tray ()p.59)
• Dot Process ()p.63)
• Memory ()p.125)
• Contrast Adj ()p.65)
• Tone Curve ()p.66)
• Book Shadow ()p.80)
• Top Margin ()p.82)
• Storage Memory ()p.176)
7
Enter the number of copies using the
Print Quantity Keys.
The number is displayed on the Print Quantity Dis-
play.
Note:
• To change the number, press the
key,
then re-enter the correct number.
8
Press the
key.
The next steps are different, depending on
whether the original is scanned from Platen Glass,
or from the ADF unit.
Perform one of the following steps:
Important!:
• Either Platen Glass or ADF unit may be used,
but not both at a time.
Ready for Link Print
Selections
Basic
Functions
Admin.
P.1/6
LBP1
MP
1
2
Idle
A4
A3
B4
Duplex
Cancel
OK
Page Total
Short Edge
OFF
A B
A
B
Even
Odd
Long Edge
Ready for Link Print
Selections
Basic
Functions
Admin.
P.1/6
LBP1
MP
1
2
Idle
A4
A3
B4
Duplex
Cancel
OK
Page Total
Short Edge
OFF
A B
A
B
Even
Odd
Long Edge