Riso RZ 970 Series User Manual - page 251
Troubleshooting
Troubleshooting
250
Paper gets jammed in the Auto
Document Feeder DX-1
(option).
There is any paper caught in the Auto
Document Feeder DX-1.
Removing originals jammed in the
original reversal unit
Open the auto document feeder cover
(
), and raise the document tray as
shown in (
).
Pull out the original (
).
Removing originals jammed in the
original receiving unit
Lift the Platen Cover Pad up (
), and pull
the release lever toward you (
), and
pull out the original (
).
Printed copies are not neatly
aligned in the Paper Receiving
Tray.
The positions of the Receiving Tray
Paper Guides and the Paper Stopper
are inappropriate.
(For RZ970)
Adjust the Receiving Tray Paper Guides
and the Paper Stopper to the size of
paper. For thick paper, slightly widen them
as necessary.
If you have adjusted the horizontal
position on the Standard Feed Tray, shift
the Receiving Tray Paper Guides in the
same direction.
The Paper Arrangers are not properly
set.
Set the Paper Arrangers properly.
The Paper Feed Pressure
Adjustment Lever is positioned
incorrectly.
If the Paper Feed Pressure Adjustment
Lever is set to “Thick Paper”, printed
copies may not be correctly aligned when
using standard paper.
Set the Paper Feed Pressure Adjustment
Lever to “Standard”.
Problem
Possible Cause
Action