Riso RZ 970 Series User Manual - page 80
Functions for Master-Making
Printing Multiple Originals on One Sheet [2 Up] [Multi-Up Print]
79
6
Touch
or
to specify the short
edge size of the original (the width).
Important!:
• If you have enlarged/reduced size in step 8
(setting print functions), be careful about the fol-
lowing points.
– Specify the ticket width after enlarging/reduc-
ing.
– If you magnified the size, make sure that the
bigger size does not exceed the specified
“Page Width” or the short edges of the print
paper.
– When magnifying, make sure to prepare
paper that fits the enlarged size.
7
Touch [OK].
The following screen appears.
Returns to the Functions screen. “Multi-Up Tick-
ets” setting is updated.
Note:
• To cancel a “Multi-Up Print” setting once it has
been confirmed, follow steps 3 and 4, touch
[OFF] and then [ON] on the screen.
8
Make necessary settings.
Make various settings as needed.
9
Press the
key.
Starts scanning of the original.
After this, please follow the same operations for
normally printing.
Cancel
OK
Multi-Up Tickets
(Numeric keypad is
available for input)
Set the original
in direction shown
in the right figure
Page Width
mm
Cancel
OK
Multi-Up Tickets
(Numeric keypad is
available for input)
Set the original
in direction shown
in the right figure
Page Width
8 0
mm
Basic
Selections
Functions
Admin.
P.
Programme
Digital Copy Count
1/4
Job Memory
Job Memory
Dot Process
Contrast Adj
Tone Curve
Ready to Make Master Multi-Up
Multi-Up Print
2 Up
Cancel
OK
Multi-Up Tickets
(Numeric keypad is
available for input)
Set the original
in direction shown
in the right figure
Page Width
8 0 mm
OFF