D-Link xStack DGS-3600 Series User Manual - page 169
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Key ID (1-255)
A number from
1
to
255
used to identify the MD5 Key.
Key
A alphanumeric string of between 1 and 16 case-sensitive characters used to generate the
Message Digest which is in turn, used to authenticate OSPF packets within the OSPF routing
domain.
Click
Apply
to enter the new Key ID settings. To delete a Key ID entry, click the corresponding under the Delete heading.
Route Redistribution Settings
Route redistribution allows routers on the network, which are running different routing protocols to exchange routing information.
This is accomplished by comparing the routes stored in the various routers’ routing tables and assigning appropriate metrics. This
information is then exchanged among the various routers according to the individual router’s current routing protocol. The Switch
can redistribute routing information between the OSPF and RIP routing protocols to all routers on the network that are running
OSPF or RIP. Routing information entered into the Static Routing Table on the local Switch is also redistributed.
Entering the metric 0 specifies transparency.
This window will redistribute routing information between the OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. To access the
Route Redistribution Settings
window, go to
> L3 Features > Route Redistribution
Settings
:
Figure 8- 8. Route Redistribution Settings window
The following parameters may be set or viewed:
Parameter
Description
Dst. Protocol
Allows for the selection of the protocol for the destination device. Choose between
RIP
and
OSPF.
Src. Protocol
Allows for the selection of the protocol for the source device. Choose between
RIP
,
OSPF,
Static
and
Local
.
Type
Allows for the selection of one of six methods of calculating the metric value. The user may
choose between
All
,
Internal
,
External
,
ExtType1
,
ExtType2
,
Inter-E1
,
Inter-E2
.
Metric (0-16)
Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in the RIP
routing protocol. The user may specify a cost between
0
and
16
.
Click
Add/Modify
to implement changes made.
NOTE:
The source protocol (Src. Protocol) entry and the destination
protocol (Dst. Protocol) entry cannot be the same.
153