D-Link xStack DGS-3600 Series User Manual - Snmp Trap Settings
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
SNMP Trap Settings
The following window is used to enable and disable trap settings for the SNMP function on the Switch. To view this window for
configuration, click
Administration > SNMP Manager > SNMP Trap Settings
:
Figure 6- 32. SNMP Trap Settings window
To enable or disable the Traps State, Authenticate Trap State, and/or Linkchange Trap State use the corresponding pull-down
menu to change and click
Apply
.
To enable or disable linkchange trap settings for individual ports, select the ports using the From and To drop-down menus, enable
State using the drop-down menu, and then click
Apply
.
SNMP User Table
This window
displays all of the SNMP users currently configured on the Switch.
In the
SNMP Manager
folder, located in the
Administration
folder, click on the
SNMP User Table
link. This will open the
SNMP User Table
window, as shown below.
58