D-Link xStack DGS-3600 Series User Manual - Bandwidth Control
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Bandwidth Control
The bandwidth control settings are used to place a ceiling on the transmitting and receiving data rates for any selected port. In the
QoS
folder, click
Bandwidth Control
, to view the window shown below.
Figure 9- 2. Bandwidth Settings window
Click
Apply
to set the bandwidth control for the selected ports. Results of configured Bandwidth Settings will be displayed in the
Port Bandwidth Table.
The following parameters can be set or are displayed:
Parameter Description
From/To
A consecutive group of ports may be configured starting with the selected port.
Type
This drop-down menu allows you to select between
RX
(receive),
TX
(transmit), and
Both
. This setting will determine whether the bandwidth ceiling is applied to receiving,
transmitting, or both receiving and transmitting packets.
No Limit
This drop-down menu allows you to specify that the selected port will have no bandwidth
limit.
Enabled
disables the limit.
Rate (1-
156249)
This field allows the user to enter the data rate that will be the limit for the selected port.
225