D-Link xStack DGS-3600 Series User Manual - System Log
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
System Log
The
System Log
folder contains two main windows
System Log Host
and
System
Log Save Mode Settings
.
System Log Host
The Switch can send Syslog messages to up to four designated servers using the System Log Server. In the
Administration
folder, click
System Log > System Log Host
to view the window shown below.
Figure 6- 14. System Log Host window
The parameters configured for adding and editing
System Log Server
settings are the same. See the table below for a description.
Figure 6- 15. Configure System Log Server – Add window
To set the System Log Server configuration, click
Apply
. To delete an entry from the
System Log Host
window, click the
corresponding
under the Delete
heading of the entry to delete. To return to the
System Log Host
window, click the
Show All
System Log Servers
link.
The following parameters can be set:
Parameter Description
Index
Syslog server settings index (
1
to
4
).
Server IP
The IP address of the Syslog server.
Severity
This drop-down menu allows you to select the level of messages that will be sent. The options
are
Warning
,
Informational
, and
All
.
Facility
Some of the operating system daemons and processes have been assigned Facility values.
Processes and daemons that have not been explicitly assigned a Facility may use any of the
"local use" facilities or they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following:
Bold
font indicates the facility values that the Switch is
currently employing.
Numerical Facility
Code
42