D-Link xStack DGS-3600 Series User Manual - Side Panel Description
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 1- 12. Rear panel view of the DGS-3612G
DGS-3627 and DGS-3627G
The rear panel of DGS-3627 and DGS-3627G contain an AC power connector, an outlet for an optional external RPS, and three
slots for additional 10GE optional modules.
Figure 1- 13. Rear panel view of the DGS-3627 and DGS-3627G
DGS-3650
The rear panel of DGS-3650 contains an AC power connector, an outlet for an optional external RPS, a DCE RS-232 console port,
and two slots for additional 10GE optional modules.
Figure 1- 14. Rear Panel view of DGS-3650
The rear panel includes an outlet for an optional external redundant power supply. When power fails, the optional external RPS
will take over all the power immediately and automatically. The AC power connector is a standard three-pronged connector that
supports the power cord. Plug-in the female connector of the provided power cord into this socket, and the male side of the cord
into a power outlet. The Switch automatically adjusts its power setting to any supply voltage in the range from 100 ~ 240 VAC at
50 ~ 60 Hz.
Side Panel Description
The right-hand side panel of the Switch contains a system fan and ventilation along the entire right side. The left hand panel
includes a system fan and a heat vent. The system fans are used to dissipate heat. Do not block these openings on either side of the
Switch. Leave at least 6 inches of space at the rear and sides of the Switch for proper ventilation. Be reminded that without proper
heat dissipation and air circulation, system components might overheat, which could lead to system failure.
Figure 1- 15. Side Panel of the DGS-3612G
Figure 1- 16. Side Panel of the DGS-3612
5