D-Link xStack DGS-3600 Series User Manual - Section 10
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Section 10
ACL
Time Range
Access Profile Table
ACL Flow Meter
CPU Interface Filtering
Time Range
This window is used in conjunction with the Access Profile feature to determine a starting point and an ending point, based on
days of the week, when an Access Profile configuration will be enabled on the Switch. Once configured here, the time range
settings are to be applied to an access profile rule using the Access Profile
table. The user may enter up to 64 time range entries on
the Switch.
NOTE:
The Time Range commands are based on the time settings of the Switch.
Make sure to configure the time for the Switch appropriately for these commands
using commands listed in the following chapter, Time and SNTP Commands.
To open the Time Range window, click
ACL > Time Range
, which will display the following window for the user to configure.
Figure 10- 1. Time Range Settings window
The user may adjust the following parameters to configure a time range on the Switch:
Parameter
Description
Range Name
Enter a name of no more than 32 alphanumeric characters that will be used to identify this
time range on the Switch. This range name will be used in the Access Profile
table to identify
the access profile and associated rule to be enabled during this time range.
Hours (HH MM SS)
This parameter is used to set the time in the day that this time range is to be enabled using
the following parameters:
Weekdays
Use the check boxes to tick the corresponding days of the week that this time range is to be
enabled.
Start Time
time range, in hours, minutes and seconds, based on the 24-hour time system.
•
•
End Time
time range, in hours, minutes and seconds, based on the 24-hour time system.
230