D-Link xStack DGS-3600 Series User Manual - Ip Address
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
65535)
accessed, before it is dropped from the table. The value may be set in the range of
0
to
65535
minutes with a default setting of
20
minutes.
DVMRP State
The user may globally enable or disable the Distance Vector Multicast Routing Protocol
(DVMRP) function by using the pull-down menu.
PIM State
The user may globally enable or disable the Protocol Independent Multicast - Dense Mode
(PIM-DM) function by using the pull-down menu.
RIP State
The user may globally enable or disable the Routing Information Protocol (RIP) function by
using the pull-down menu.
OSPF State
The user may globally enable or disable the Open Shortest Path first (OSPF) function by
using the pull-down menu.
Click
Apply
to implement changes made.
IP Address
The IP Address may initially be set using the console interface prior to connecting to it through the Ethernet. If the Switch IP
address has not yet been changed, read the introduction of the
Command Line Interface Reference Manual
or return to Section 4
of this manual for more information.
To configure the Switch's IP address:
Open the
Administration
folder and click
IP Address
. The web manager will display the Switch's current IP settings in the
IP
Address
window, as seen below.
Figure 6- 2. IP Address window
To manually assign the Switch's IP address, subnet mask, and default gateway address:
1. Select
Manual
from the Get IP From drop-down menu.
2. Enter the appropriate IP Address and Subnet Mask.
3. If you want to access the Switch from a different subnet from the one it is installed on, enter the IP address of the Default
Gateway. If you will manage the Switch from the subnet on which it is installed, you can leave the default address
(0.0.0.0) in this field.
4. If no VLANs have been previously configured on the Switch, you can use the
default
VLAN Name. The
default
VLAN
contains all of the Switch ports as members. If VLANs have been previously configured on the Switch, you will need to
enter the VLAN ID of the VLAN that contains the port connected to the management station that will access the Switch.
The Switch will allow management access from stations with the same VID listed here.
31