D-Link xStack DGS-3600 Series User Manual - page 275
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 35. CPU Interface Filtering Rule Configuration window (IP)
Configure the following Access Rule Configuration
settings for IP:
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny
to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Access ID
Type in a unique identifier number for this access and priority. This value can be set from
1
to
100
.
Type
Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source IP
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP
Destination IP Address- Enter an IP Address mask for the destination IP address.
DSCP (0-63)
This field allows the user to enter a DSCP value in the space provided, which will instruct the
Switch to examine the DiffServ Code part of each packet header and use this as the, or part of
the criterion for forwarding. The user may choose a value between
0
and
63
.
Port
The CPU Access Rule may be configured on a per-port basis by entering the port number of the
Switch.
Time Range
Click the check box and enter the name of the Time Range settings that has been previously
configured in the
Time Range Settings
window. This will set specific times when this CPU
access rule will be implemented on the Switch.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
•
•
•
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
IPv6
instructs the Switch to examine the IPv6 part of the packet header.
To view the settings of a previously correctly configured rule, click
in the
Access Rule Table
to view the following window:
259