D-Link xStack DGS-3600 Series User Manual - Glossary
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Glossary
1000BASE-SX:
A short laser wavelength on multimode fiber optic cable for a maximum length of 2000 meters
1000BASE-LX:
A long wavelength for a "long haul" fiber optic cable for a maximum length of 10 kilometers
100BASE-TX:
100Mbps Ethernet implementation over Category 5 and Type 1 Twisted Pair cabling.
ATM:
Asynchronous Transfer Mode. A connection oriented transmission protocol based on fixed length cells (packets). ATM is
designed to carry a complete range of user traffic, including voice, data and video signals.
auto-negotiation:
A feature on a port, which allows it to advertise its capabilities for speed, duplex and flow control. When
connected to an end station that also supports auto-negotiation, the link can self-detect its optimum operating setup.
backbone:
The part of a network used as the primary path for transporting traffic between network segments.
bandwidth
: Information capacity, measured in bits per second that a channel can transmit. The bandwidth of Ethernet is 10Mbps,
the bandwidth of Fast Ethernet is 100Mbps.
100BASE-FX
: 100Mbps Ethernet implementation over fiber.
10BASE-T:
The IEEE 802.3 specification for Ethernet over Unshielded Twisted Pair (UTP) cabling.
Ethernet:
A LAN specification developed jointly by Xerox, Intel and Digital Equipment Corporation. Ethernet networks operate
at 10Mbps using CSMA/CD to run over cabling.
forwarding:
The process of sending a packet toward its destination by an internetworking device.
aging:
The automatic removal of dynamic entries from the Switch Database which have timed-out and are no longer valid.
backbone port:
A port which does not learn device addresses, and which receives all frames with an unknown address. Backbone
ports are normally used to connect the Switch to the backbone of your network. Note that backbone ports were formerly known as
designated downlink ports.
baud rate
: The switching speed of a line. Also known as line speed between network segments.
BOOTP:
The BOOTP protocol allows you to automatically map an IP address to a given MAC address each time a device is
started. In addition, the protocol can assign the subnet mask and default gateway to a device.
bridge
: A device that interconnects local or remote networks no matter what higher-level protocols are involved. Bridges form a
single logical network, centralizing network administration.
broadcast:
A message sent to all destination devices on the network.
broadcast storm
: Multiple simultaneous broadcasts that typically absorb available network bandwidth and can cause network
failure.
console port:
The port on the Switch accepting a terminal or modem connector. It changes the parallel arrangement of data within
computers to the serial form used on data transmission links. This port is most often used for dedicated local management.
CSMA/CD
: Channel access method used by Ethernet and IEEE 802.3 standards in which devices transmit only after finding the
data channel clear for some period of time. When two devices transmit simultaneously, a collision occurs and the colliding
devices delay their retransmissions for a random amount of time.
data center switching
: The point of aggregation within a corporate network where a switch provides high-performance access to
server farms, a high-speed backbone connection and a control point for network management and security.
Fast Ethernet:
100Mbps technology based on the Ethernet/CSMA/CD network access method.
Flow Control:
(IEEE 802.3z) A means of holding packets back at the transmit port of the connected end station. Prevents packet
loss at a congested switch port.
full duplex:
A system that allows packets to be transmitted and received at the same time and, in effect, doubles the potential
throughput of a link.
half duplex:
A system that allows packets to be transmitted and received, but not at the same time. Contrast with full duplex.
IP address:
Internet Protocol address. A unique identifier for a device attached to a network using TCP/IP. The address is written
as four octets separated with full-stops (periods), and is made up of a network section, an optional subnet section and a host
section.
IPX:
Internetwork Packet Exchange. A protocol allowing communication in a NetWare network.
LAN - Local Area Network:
A network of connected computing resources (such as PCs, printers, servers) covering a relatively
small geographic area (usually not larger than a floor or building). Characterized by high data rates and low error rates.
372