D-Link xStack DGS-3600 Series User Manual - page 277
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 10- 3 . CPU Interface Filtering Rule Configuration window (Packet Content Mask)
8
To set the Access Rule for Ethernet, adjust the following parameters and click
Apply
.
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by
the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from
1
to
100
.
Type
Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask, or IPv6.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
•
•
•
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header.
IPv6
instructs the Switch to examine the IPv6 part of the packet header.
261