D-Link xStack DGS-3600 Series User Manual - page 205
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
ID
MD5 Key Settings
window.
Transmit Delay
The number of seconds required to transmit a link state update over this virtual link. Transit
delay takes into account transmission and propagation delays. This field is fixed at 1
second.
Retransmit Interval
The number of seconds between link state advertisement retransmissions for adjacencies
belonging to this virtual link. This field is fixed at 5 seconds.
Click
Apply
to implement changes made.
NOTE:
For OSPF to function properly some settings should be identical on all
participating OSPF devices. These settings include the Hello Interval and Dead
Interval. For networks using authorization for OSPF devices, the Authorization Type
and Password or Key used must likewise be identical.
OSPF Area Aggregation Settings
Area Aggregation allows all of the routing information that may be contained within an area to be aggregated into a summary
LSDB advertisement of just the network address and subnet mask. This allows for a reduction in the volume of LSDB
advertisement traffic as well as a reduction in the memory overhead in the Switch used to maintain routing tables. Click
L3
Features > OSPF >
OSPF Area Aggregation Settings
link to view the current settings. There are no aggregation settings
configured by default, so there will not be any listed the first accessing the window. To add a new OSPF Area Aggregation
setting, click the
Add
button. A new window (pictured below) appears. To change an existing configuration, click on the
corresponding
Modify
button for the set you want to change. The window to modify an existing configuration is the same as the
window used to add a new one. To eliminate an existing configuration, click the in the Delete column for the configuration
being removed.
Figure 8- 48. OSPF Area Aggregation Settings window
Use the window below to change settings or add a new OSPF Area Aggregation
setting.
Figure 8- 4 . OSPF Area Aggregation Settings – Add window
9
Specify the OSPF aggregation settings and click the
Apply
button to add or change the settings. The new settings will appear
listed in the
OSPF Area Aggregation Settings
window. To view the table, click the
Show All OSPF Aggregation Entries
link to
return to the previous window.
Use the following parameters to configure the following settings for OSPF Area Aggregation Settings:
189