D-Link xStack DGS-3600 Series User Manual - page 272
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Source IPv6 Address
The user may specify an IP address mask for the source IPv6 address by entering the IP
address mask, in hex form.
Destination IPv6
Address
The user may specify an IP address mask for the destination IPv6 address by and entering
the IP address mask, in hex form.
Click Apply to implement changes made.
To establish the rule for a previously created CPU Access Profile:
In the
ACL
folder, click
CPU Interface Filtering
to open the
CPU Interface Filtering Table
window.
Figure 10- 3 . CPU Interface Filtering Table window - Add
0
In this window, the user may add a rule to a previously created CPU access profile by clicking the corresponding
Add Rule
button of the entry to configure Ethernet, IPv4, Packet Content Mask, or IPv6.
Figure 10- 31. CPU Interface Filtering Rule Table window
Click the
Add Rule
button to continue on to the
CPU Interface Filtering Rule Table
window. A new and unique window, for
Ethernet, IP, Packet Content and IPv6 will open as shown in the examples below.
To change a rule for a previously created CPU Access Profile Rule:
The
CPU Interface Filtering Rule Configuration
window allows the user to create a rule for a previously created CPU Access
Profile.
256