D-Link xStack DGS-3600 Series User Manual - Authenticator State
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
The following windows are used to monitor 802.1x statistics of the Switch, on a per port basis. To view the
Port Access Control
windows, open the monitoring folder and click the
Port Access Control
folder. There are six windows to monitor.
NOTE:
The Authenticator State cannot be viewed on the Switch unless
802.1X is enabled by port or by MAC address. To enable 802.1x, go to the
DGS-3600 Web Management Tool window.
Authenticator State
The following section describes the 802.1x Status on the Switch. To view the Authenticator State, click
Monitoring > Port
Access Control > Authenticator State.
This window displays the Authenticator State for individual ports on a selected device. A polling interval between
1
and
60
seconds can be set using the drop-down menu at the top of the window and clicking
OK
.
0
Figure 12- 2 . Authenticator State window (Port-based 802.1x)
326