D-Link xStack DGS-3600 Series User Manual - page 260
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
NOTE:
When using the ACL Mirror function, ensure that the Port Mirroring
function is enabled and a target mirror port is set.
To configure the Access Rule for IPv6, open the
Access Profile Table
window and click
Modify
for an IPv6 entry. This will open
the following window:
Figure 10- 18. Access Rule Table window (IPv6)
To remove a previously created rule, click its corresponding
button. To add a new Access Rule, click the
Add Rule
button:
Figure 10- 1 . Access Rule Configuration window (IPv6)
9
To set the Access Rule for the IPv6, adjust the following parameters and click
Apply
.
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the Switch
and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined in
the Port Mirroring window. Port Mirroring must be enabled and a target port must be set.
244