D-Link xStack DGS-3600 Series User Manual - Port Configuration
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Port Configuration
This section contains information for configuring various attributes and properties for individual physical ports, including port
speed and flow control.
Port Configuration
Click
Administration
>
Port Configuration > Port Configuration
to display the following window:
To configure switch ports:
1. Choose the port or sequential range of ports using the From…To… port pull-down menus.
2. Use the remaining pull-down menus to configure the parameters described below:
Figure 6- 7. Port Configuration window
The following parameters can be configured:
Parameter Description
From…. To
Use the pull-down menus to select the port or range of ports to be configured.
State
Toggle this field to either enable or disable a given port or group of ports.
Speed/Duplex
Toggle the Speed/Duplex
field to either select the speed and duplex/half-duplex state of the port.
Auto
denotes auto-negotiation between 10 and 100 Mbps devices, in full- or half-duplex. The
Auto
setting allows the port to automatically determine the fastest settings the device the port is
connected to can handle, and then to use those settings. The other options are
Auto
,
10M/Half
,
10M/Full,
100M/Half
and
100M/Full
,
1000M/Full_M
and
1000M/Full_S
. There is no automatic
adjustment of port settings with any option other than Auto.
37