D-Link xStack DGS-3600 Series User Manual - page 81
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 43. SNMP Host Table Configuration window for IPv4
The following parameters can set:
Parameter Description
Host IPv4 Address
Type the IPv4 address of the remote management station that will serve as the SNMP host
for the Switch.
SNMP Version
V1
- To specifies that SNMP version 1 will be used.
V2
- To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv
- To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv
- To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv
- To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Community String or
SNMP V3 User Name
Type in the community string or SNMP V3 user name as appropriate.
To add a new IPv6 entry to the Switch's SNMP Host Table, click the
Add IPv6 Host
button in the upper left-hand corner of the
window. This will open the
SNMP Host Table Configuration
window, as shown below.
Figure 6- 44. SNMP Host Table Configuration window for IPv6
The following parameters can set:
Parameter Description
Host IPv6 Address
Type the IPv6 address of the remote management station that will serve as the SNMP host
for the Switch.
SNMP Version
V1
- To specifies that SNMP version 1 will be used.
V2
- To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv
- To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv
- To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv
- To specify that the SNMP version 3 will be used, with an Auth-Priv security
65