D-Link xStack DGS-3600 Series User Manual - Ip-Mac Binding Table
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
IP-MAC Binding Table
The window shown below can be used to create IP-MAC binding entries. Click
IP-MAC Binding Table
in the
IP-MAC-Port
Binding
folder in the
Administration
folder to view the
Address
Binding ACL Mode Settings
window. Enter the IP and MAC
addresses of the authorized users in the appropriate fields and click
Add
. To modify either the IP address or the MAC address of
the binding entry, make the desired changes in the appropriate field and Click
Modify
. To find an IP-MAC binding entry, enter
the IP and MAC addresses and click
Find
. To delete an entry click
Delete
. To clear all the entries from the table click
Delete All
.
Figure 6- 51. Address Binding ACL Mode Settings window
The following fields can be set or modified:
Parameter Description
This field will enable and disable the ACL mode for IP-MAC binding on the Switch, without
altering previously set configurations. When enabled, the Switch will automatically create two
ACL packet content mask entries that will aid the user in processing certain IP-MAC binding
entries created. The ACL entries created when this command is enabled, can only be
automatically installed if the Access Profile table has two entries available of the possible 14
entries allowed.
Address Binding
ACL Mode
This field will enable and disable the sending of trap log messages for IP-MAC binding. When
enabled, the Switch will send a trap log message to the SNMP agent and the Switch log when
an ARP packet is received that doesn’t match the IP-MAC binding configuration set on the
Switch.
ACL Binding Trap
Log
Enter the IP address you wish to bind to the MAC address set below.
IP Address
Enter the MAC address you wish to bind to the IP Address set above.
MAC Address
All Ports
Click this check box to configure this IP-MAC binding entry (IP Address + MAC Address) for all
ports on the Switch.
Ports
Mode
The user may set the IP-MAC Binding Mode here by using the pull-down menu. The choices
are:
ARP
– Choosing this selection will set a normal IP-Mac Binding entry for the IP address and
MAC address entered.
Specify the switch ports for which to configure this IP-MAC binding entry (IP Address + MAC
Address). Click the All check box to configure this entry for all ports on the Switch.
70