D-Link xStack DGS-3600 Series User Manual - page 322
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Parameter Description
SSH Server Status
Use the pull-down menu to enable or disable SSH on the Switch. The default is
Disabled
.
Max Session (1-8)
Enter a value between
1
and
8
to set the number of users that may simultaneously access the
Switch. The default setting is
8
.
Connection
Timeout (120-600)
Allows the user to set the connection timeout. The use may set a time between
120
and
600
seconds. The default setting is
120
seconds.
Auth. Fail (2-20)
Allows the Administrator to set the maximum number of attempts that a user may try to log on
to the SSH Server utilizing the SSH authentication. After the maximum number of attempts
has been exceeded, the Switch will be disconnected and the user must reconnect to the
Switch to attempt another login. The number of maximum attempts may be set between
2
and
20
. The default setting is
2
.
Session Rekeying
Using the pull-down menu uses this field to set the time period that the Switch will change the
security shell encryptions. The available options are
Never
,
10 min
,
30 min
, and
60 min
. The
default setting is
Never
.
Listened Port
Number
The virtual port number to be used with this feature. The common port number for SSH is 22.
SSH Authentication Mode and Algorithm Settings
The SSH Algorithm window allows the
configuration of the desired types of SSH
algorithms used for authentication
encryption. There are four categories of
algorithms listed and specific algorithms of
each may be enabled or disabled by using
their corresponding pull-down menus. All
algorithms are enabled by default. To open
the following window, click
Security >
SSH > SSH
Authentication Mode and
Algorithm Settings
:
Figure 11- 49. SSH Authenticate Mode and Algorithm Settings window
306