Kalkhoff Fast Pedelec User Manual - page 177
28
V User Manual Impulse Pedelec
7.4.1 Checking the battery charge state
Press the
Push
button
briefly
; the LEDs light up and dis-
play the current
battery charge state
.
DISPLAY
BATTERY CHARGE STATE
•••••
5 LEDs light up
100 – 84%
••••
4 LEDs light up
83 – 68%
•••
3 LEDs light up
67 – 51%
••
2 LEDs light up
50 – 34%
•
1 LED lights up
33 – 17%
¡
1 LED flashes
16 – 0%
5 LEDs flash quickly
0% or overloaded *
1. LED flashes quickly Charging fault **
* All 5 LEDs flash quickly: The battery is empty and is
being switched off, or is overloaded.
›
If the battery is overloaded, it will switch back
on after a short idle period and can then be used
normally.
›
If the battery is empty, it will work once again
briefly following a short period of rejuvenation and
will then switch back off. It must now be charged.
** The 1st LED flashes quickly: A charging fault is present.
›
If this occurs, put the battery in the docking station
for a short period of time or insert the plug of the
charger into the battery. The charger performs a
readjustment. If the LED still flashes, take the
battery to your specialist cycle shop and have it
checked.
7.4.2 Checking the battery capacity
If you press the “Push” button for
five seconds
, the LEDs
show the current
capacity
of the battery.
DISPLAY
CAPACITY
•••••
5 LEDs light up
100 – 97%
••••
4 LEDs light up
96 – 80%
•••
3 LEDs light up
79 – 60%
••
2 LEDs light up
59 – 40%
•
1 LED lights up
39 – 20%
¡
1 LED flashes
7.4 Battery information system
There is a display panel on the outer face of the battery
which includes five LEDs and a button with an LED (
Push
).
When you press the
Push
button, the LEDs light up. Infor-
mation about the battery and its charge state is provided
based on the number of LEDs that light up and the way in
which they light up.
Charge state and battery capacity indicator