Kalkhoff Fast Pedelec User Manual - page 80

II User Manual Fast Pedelec 

  11

4.1.3   Changing the assist level

Increase power assist

The following assist levels are displayed one by one when 

you press the button for selecting a more powerful assist 

level: "

NO ASSIST / no assistance"

, 

"ECO / low assist level"

, 

"STANDARD / medium assist level"

, 

"HIGH / high assist 

level"

, followed once again by 

"NO ASSIST / no assistance"

. 

This means that the assistance increases each time you 

press the button until you reach the highest power level. 

If you subsequently press the button, the assistance 

switches off.

Reduce power assist

If you press the button that reduces the assist level, the 

assistance reduces each time the button is pressed and 

returns to the most powerful assist level when it reaches 

the end of the loop.

In the 

"NO ASSIST / no assistance"

 mode, you ride the bike 

normally without the assistance of the motor.

4.1.4   Resetting recorded data

If you press the selector button for the display panel for 

longer than three seconds with the control panel switched 

on, this resets the trip, average speed and top speed to 

zero. You cannot delete the total journey length using this 

method.

4.1.5   Switching the display on and off

The back-lit display and LCD control panel display can 

also be switched on even if the drive is not enabled. To 

do this, press the button that switches the lights on. The 

drive remains in "

NO ASSIST / no assistance" mode

. Now 

you cannot change the assist level.

If you press the light button when the control panel is 

switched on, the back-lit display turns on.

If you press the light switch when the light is on, the back-

lit display turns off. The power assist is still available and 

you can change the assist level.

4.1.6   Deleting all data

Press the display ("Mode") selector button and the button 

that deletes all data on the rear of the control panel at the 

same time to delete all the data stored, including the total 

journey length. The display then automatically switches 

to settings mode for language, LCD contrast and wheel 

circumference.