Kalkhoff Fast Pedelec User Manual - page 197

VII User Manual | Pedelec Groove  

  15

15

Do not use other chargers. Only charge the battery us-

ing the charger provided, or a charger approved by us.

If a problem occurs, remove the battery from the Pe-

delec and place it briefly in the charger. The charger 

tests the battery and corrects any faults that may be 

present.

If used incorrectly, the device may be damaged or 

inflict injuries. 

›

Before cleaning the charger, always pull the plug 

out of the socket to avoid a short-circuit and/or 

physical injury. 

›

Only use the charger in dry rooms. 

›

Only place the charger in an upright, secure and 

stable position on a suitable surface. 

›

Do not cover the charger or place any objects on 

it as otherwise it could overheat and catch fire. 

9  Removing the front wheel

If you need to remove the front wheel, to repair a punc-

ture for example, this can be done in the same way as 

removing the front wheel of a normal bike, excluding one 

procedure.

›

The first thing you must do before releasing the 

front wheel is to open the connection to the front 

wheel motor. 

›

Undo the locking nut for the electrical connector 

which is located on the back of the fork. Take the up-

per half of the connector in one hand and the lower 

half in the other and pull the two halves apart.

1  Locking nut 

2  Cable tie

 1

 2

The lower half of the connector and the power cable are 

fastened to the fork with two cable ties.  

›

Slide the cable ties down and off the fork. You can 

now remove the front wheel. You can find corre-

sponding instructions in the section of this User 

Manual that deals with general bike technology.  If 

you take the front wheel out of the fork, also pull 

the cable and cable tie off the fork.

›

To reinstall the front wheel, slide the cable tie 

with cable onto the fork leg before positioning the 

wheel in the fork. Install the front wheel as de-

scribed in the general section of this User Manual.

›

Next, reattach the two halves of the connector and 

screw the lock nut firmly back on. Slide the two ca-

ble ties back up the fork until they remain in place 

of their own accord and cannot slip.