Oki MB472dn User Manual - page 1044
of
1137
Enabling the User Limit
You must be the administrator to control access to the machine.
1.
Press
(SETTING).
2.
Press to select [Admin Setup], and then press (OK).
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Select [Enter], and then press (OK).
5.
Press to select [Management], and then press (OK).
6.
Press to select [System Setup], and then press (OK).
7.
Check that [Access Control] is selected, and then press (OK).
8.
Press to select [PIN], and then press (OK).
9.
A specified authentication method is applied, and then press until the message "Access control
became valid." is displayed.
1043