Oki MB472dn User Manual - page 600
User Install
Set the time and other settings.
1.
Press
(SETTING).
2.
Select [Admin Setup], and then press (OK).
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Select [Enter], and then press (OK).
5.
Press to select [User Install], and then press (OK).
6.
Change the setting, and then press (OK).
7.
Press until the top screen is displayed.
Item
Factory default
setting
Description
Time Zone
00:00
Sets the time GMT zone.
Available range: -12:00 to +13:00 (15 minutes/increment)
Set Daylight Saving
ON
Sets whether to enable the Daylight Saving mode.
Time Setup
Auto
Setup
SNTP Server
(Primary)
Sets the SNTP server to use for setting the current date and time. You can
enter up to 64 characters.
SNTP Server
(Secondary)
Manual Setup
2001/1/1
0:00:00
Sets the current date and time manually.
Power Setup Auto Power Off
Auto Config
Sets the behavior of Automatic Power Off.
Power Supply Return
Manual
Sets whether to enable Power Save Mode.
High Humid Mode
OFF
Sets whether to enable the humidity mode.
Quiet Mode
OFF
Sets the low-speed print mode to reduce printing noise.
MF (Tone)/DP (Pulse)
Tone
Select a dial type.
Tone
Pulse
Reception Mode
Fax Ready Mode
Sets a reception mode.
Fax Ready Mode
Tel/Fax Ready Mode
Ans/Fax Ready Mode
Tel Ready Mode
DRD (Distinctive Ring Detection)
DRD Type
Type 1
Set Distinctive Ring Detection.
Type 1
Type 2
Type 3
Type 4
Dial Tone Detection
OFF
Sets whether to detect a dial tone.
Busy Tone Detection
ON
Sets whether to detect a busy tone.
Monitor Control
OFF
Select from three choices.
OFF: Not to monitor.
Type 1: Monitor till receiving/sending the first valid facsimile signal.
Type 2: Execute Type 1 monitoring during communication.
Monitor Volume
Middle
Sets the Monitor Volume.
OFF
Low
599