Oki MB472dn User Manual - page 724
Adjusting the Density When Scanning
This section describes how to change the default setting of the density when scanning. You can adjust the density in seven levels.
1.
Press
(SETTING).
2.
Press to select [Admin Setup], and then press (OK).
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Select [Enter], and then press (OK).
5.
Press to select [Scanner Setup], and then press (OK).
6.
Press to select [Default Settings], and then press (OK).
7.
Press to select [Image Settings], and then press (OK).
8.
Press to select [Density], and then press (OK).
9.
Press or to select a value, and then press (OK).
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or
[-3] (lightest).
723