Oki MB472dn User Manual - page 555
sound.
paper when the temperature inside is high.
with the operation.
The machine does not
start printing
immediately.
The machine is warming up to exit Power
Save, Sleep mode, or Deep Sleep mode.
You can set to extend the time of period
for entering Power Save mode, Sleep
mode or Deep Sleep mode by following
the procedure below.
Press
(SETTING), and then select
[Management] > [Power Save] > [Power
Save Time] > [Sleep Time].
The machine may be cleaning the image
drum.
Wait for a while.
-
The machine is adjusting the temperature of
the fuser unit.
Wait for a while.
-
The machine is processing data from
another interface.
Wait until printing is completed.
-
Even if the [Density]
setting is changed,
printing results do not
change.
-
-
Printing stops
halfway.
The temperature inside the machine rises
due to continuous printing for a long time,
resulting in the temperature being adjusted.
Wait for a while.
When the machine reaches the suitable
temperature, printing restarts
automatically.
-
The specified settings
such as the time
setting have been
erased.
The machine is left turned off for a long
time, or turn the machine on and off every
time you use the machine.
The battery may reach its lifetime. Contact
your dealer.
-
Free space in memory
is insufficient.
The print data is complicated.
Simplify the print data.
-
All pages are not
printed.
The WSD port is used.
Change the print port to Standard TCP/IP
Port.
-
Printing is slow.
Printing process is also processed in the
computer.
Use a computer with faster processing
speed.
-
You have selected [High Quality (Multiple
tones)] on the [Print Job Options] tab of the
printer driver.
Select [Fine / Detail (600x1200)] or
[Normal (600x600)] on the [Job Options]
tab of the printer driver.
-
The print data is complicated.
Simplify the print data.
-
The printer driver is
not correctly
displayed. (Mac OS X)
The printer driver may not be operating
correctly.
Uninstall the printer driver, and then install
it again.
The machine turns off
automatically.
If the machine is not used for a certain
period of time (the factory default is
4 hours), the machine turns off
automatically. This function is called Auto
Power Off.
Press
(SETTING), and then select
[Admin Setup] > [User Install] > [Power
Setup] > [Auto Power Off] and disable the
function.
554