Oki MB472dn User Manual - page 599
Power Save
Power Save Time
1 minute
Sets when to enter Power Save mode.
Sleep Time
30 minutes
Sets when to enter Sleep mode.
Auto Power Off Time
4 hours
Sets when to enter Auto Power Off.
Silent Mode
ON
Specifies a print preparation operation when entering standby status from
Sleep mode.
If [ON] is set: it is quiet as there is no print preparation.
If [OFF] is set: there is a rotation noise of the image to perform print
preparation but you can start first printing early.
ECO Mode*
1
ON
If [ON] is set: Printing starts even before the temperature of the fuser
reaches the prescribed degrees, if the job is small.
If [OFF] is set: Printing starts after the temperature of the fuser reaches
the prescribed degrees.
Memory Setup Receive Buffer Size
Auto
Sets the reception buffer size that local interface secures.
Resource Save
OFF
Sets the resource save area.
Flash Memory
Setup*
1
FLASH0:
Initialize
Execute
Initializes flash memory.
Display condition: [Initial Lock] is set to [Disable].
SD0:
Initialize
Execute
Format
Partition
PCL
(NULL)
Formats a partition.
Common (NULL)
Storage
Maintenance
Setup
Initial Lock
Enable
Sets whether to give permission to change settings associated with the
memory initialization.
Encryption
Setup
Job Limitation
Disable
If [Encrypted Job only] is selected, all requests for print except encrypted
authentication printing are ignored.
Language
Maint Setup
Initialize*
1
Execute
Deletes downloaded message files.
Admin
Password
New Password
Enter password
(Verify)
aaaaaa
Changes the administrator password. 6 to 12 characters can be used.
Reset Settings*
2
Execute
Deletes job macros, fax transmission/reception data, and the history
information, and returns the settings to the default.
Job Log Setup
Save Job Log*
1
Enable
Sets whether to save job logs.
Clear Job
Log*
3
Execute
Clears the saved job logs.
Display condition: [Save Job Log] is set to [Enable].
Print Statistics
Supplies Report
Disable
Sets whether to print the consumable counter's report.
Reset Main
Counter
Execute
Resets the main counter.
Reset
Supplies
Counter
Execute
Reset the consumable counter.
Display condition: [Supplies Report] is set to [Enable].
*1
A message is displayed to confirm the equipment restarts automatically when changes have been made. Select [Yes] to continue.
Select [No] to cancel.
*2
A message is displayed to confirm the equipment restarts automatically when executed. Select [Yes] to continue. Select [No] to
cancel.
*3
A message is displayed to confirm that all job logs are deleted when executed. Select [Yes] to continue. Select [No] to cancel.
598