Oce CS2436 User Manual - page 447
Handling Paper (CS2436-6)
6. 2. 14.
Handling Paper > Handling rolls >
Cutting the Leading Edge of Roll Paper Automatically
If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this
case, set
Trim Edge First
to
Automatic
or
On
in the
Paper Menu
on the Control Panel to have the printer cut
the leading edge to make the edge straight after you load a roll.
Trim Edge First
offers the following options.
●
Automatic
If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or
more when you load the roll, the edge is cut an amount relative to the slant to ensure a straight edge,
and scraps are removed. The edge is not cut if the unevenness is less than 3 mm. However, paper may
sometimes be cut, depending on the state of the leading edge.
●
Off
The edge is not cut and scraps are not removed. This setting is
Off
for most types of paper, by default.
For more information (See "Types of Paper (
6.1.1
).")
●
On
The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut from
the leading edge varies depending on the type of paper. For more information (See "Types of
Paper (
6.1.1
).")
Follow these steps to change the
Trim Edge First
setting.
1.
On the
Tab Selection screen
of the Control Panel, press or to select the Paper tab (
).
Note
・
If the
Tab Selection screen
is not displayed, press the
Menu
button.
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp04.html (42 of 63) [4-3-2010 11:36:31]