Oce CS2436 User Manual - page 456
Handling Paper (CS2436-6)
6. 3. 3.
Handling Paper > Handling sheets >
Printing From a Desired Starting Point
When printing inside boundaries or in other situations when you want to specify a particular position to start
printing from, set
Width Detection
to
Off
in the printer menu for the type of paper used.
Set Width Detection to Off
1.
On the
Tab Selection screen
of the Control Panel, press or to select the Paper tab (
).
Note
・
If the
Tab Selection screen
is not displayed, press the
Menu
button.
2.
Press the
OK
button.
The
Paper Menu
is displayed.
3.
Press or to select
Paper Details
, and then press the
OK
button.
4.
Press or to select the type of paper, and then press the
OK
button.
5.
Press or to select
Width Detection
, and then press the
OK
button.
6.
Press or to select
Off
, and then press the
OK
button.
Load paper in the desired position to start printing from
Follow these instructions to load paper at the desired starting position for printing when
Width Detection
is
Off
.
1.
If you did not send a print job in advance, a menu for selection of the type of paper is displayed.
Press or to select the type of paper, and then press the
OK
button.
Note
・
If a print job was received before paper was advanced, the media type and size
specified by the job are shown on the Display Screen.
Thus, this screen is not displayed. Go to step 2.
2.
"
Width Detection OFF. OK to continue?
" is now shown on the Display Screen. Press or to select
"
Leave OFF
", and then press the
OK
button.
3.
After a menu for selection of the paper size is displayed, press or to select the paper size, and then
press the
OK
button.
4.
Open the Top Cover and check the position where paper is loaded.
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp04.html (51 of 63) [4-3-2010 11:36:31]