Oce CS2436 User Manual - page 710
Troubleshooting (CS2436-11)
11. 6. 1.
Troubleshooting > Cannot print over a network >
Cannot connect the printer to the network
Cause
Corrective Action
The Ethernet cable is
not connected
correctly to the
printer's Ethernet
port.
1.
Make sure the printer is connected to the
network with the correct Ethernet cable, and
then turn the printer on. For instructions on
connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The bottom indicator is green if the printer is
connected via 1000Base-T, while the top
indicator is orange if connected via 100Base-TX
and the top indicator is green if connected via
10Base-T.
If the Link indicator is not lit, check the
following points.
・
Make sure the hub is on.
・
Make sure the end of the Ethernet cable is
connected correctly.
Insert the Ethernet cable until it clicks and
locks in place.
・
Make sure there is no problem with the
Ethernet cable.
If there is any problem, replace the Ethernet
cable.
・
Check the communication mode with the
hub.
Although the printer normally detects the hub
communication mode and transmission rate
automatically (in auto negotiation mode),
sometimes the hub settings cannot be
detected. In this case, configure the
connection method manually, specifying the
communication mode in use.
(See "Configuring the Communication Mode
Manually (
9.1.12
).")
2]
file:///H|/ITC-dd/Projects/Ud/WFPS/oostende%205/...port/iPF750%20User%20Manual/lang/print/cp08.html (52 of 75) [4-3-2010 11:37:2